Restauracion placa o emblema trasero santana
Publicado: Vie May 12, 2017 9:49 am
Apreciados serieros: pa que no digan que los novatos solo preguntamos y preguntamos y no aportamos al foro...aquí va mi humilde contribución y con mucho orgullo...no será nada mecánico ni complejo pero puede interesarle a alguien.
Esto se hizo con ayuda de una amiga que tiene un pulso del carajo para pintar las létricas más chiquitas...entonces el mérito es para ella...
1. Compré la placa a Leonardo Rosero por unos $10000 creo.
2. Se lijó con cariño y lija fina (500 y despues 1000)para eliminar rayones y con especial esfuerzo en los bordes de los relieves... se limpió la superficie con vinagre y un buen desemgrasante para asegurar adherencia del masking y pintura
3. Se pintaron todos los caracteres en relieve con masking líquido especial importado que usan los expertos en aerografia o aficionados a maquetas miniaturas =micromask que es acuoso y se retira facil (no apto para maraqueros o si se acaban de bajar de un series...). Algunos usan silicona líquida o vaselina también sirve.
4. Se pinta con aerosol con cualquier pintura negra brillante de calidad (no acuosa)
5. Tras el secado se retira el masking soluble en agua, de ser necesario se corrijen los bordes que tengan desperfectos
6. Protección final con laca brillante....et voila!!!
Me falta subirles la foto ya instalado en Mc Kenzie...
Esto se hizo con ayuda de una amiga que tiene un pulso del carajo para pintar las létricas más chiquitas...entonces el mérito es para ella...
1. Compré la placa a Leonardo Rosero por unos $10000 creo.
2. Se lijó con cariño y lija fina (500 y despues 1000)para eliminar rayones y con especial esfuerzo en los bordes de los relieves... se limpió la superficie con vinagre y un buen desemgrasante para asegurar adherencia del masking y pintura
3. Se pintaron todos los caracteres en relieve con masking líquido especial importado que usan los expertos en aerografia o aficionados a maquetas miniaturas =micromask que es acuoso y se retira facil (no apto para maraqueros o si se acaban de bajar de un series...). Algunos usan silicona líquida o vaselina también sirve.
4. Se pinta con aerosol con cualquier pintura negra brillante de calidad (no acuosa)
5. Tras el secado se retira el masking soluble en agua, de ser necesario se corrijen los bordes que tengan desperfectos
6. Protección final con laca brillante....et voila!!!
Me falta subirles la foto ya instalado en Mc Kenzie...